Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Manual dsc control remoto 1

WS Wireless Key WS Clé sans ?l Llave inalámbrica WS SHUDWLQJ QVWUXFWLRQV RWLFH G HPSORL QVWUXFFLRQHV GH IXQFLRQDPLHQWR Congratulations on the purchase of the WS DSC's newest button wire- less key This key will allow you to arm and disarm as well as other keypad LED functions with the convenience of wireless portability Together with your installer you can decide which functions you wish to have accessible from your portable key To activate press and hold the appropriate button for approximately sec- ond The LED located between buttons and will con ?rm that a signal has been sent to the control panel receiver False Alarm Prevention By default the key is a panic button It will require the user to press and hold for approximately seconds This was designed to reduce the possibility of a false alarm NOTE Signals will not be received if the key is not within the range of the wireless receiver The default functions are as follows Stay Arming Press this button to arm your system in the Stay mode All perimeter zones will be armed such as all window and door contacts but the interior zones will remain inactive allowing you to stay on the premises without setting o ? an alarm Away Arming Press this button to arm your system in the Away mode Both the interior and exterior zones will be armed allowing you to exit the premises Disarm Press this button to disarm your system You do not have to enter your access code when you use the key to disarm the system Panic Press this button to notify your central monitoring station of a situation requiring the police such as a break-in Other options are available Please discuss all WS options with your installer in order to program the best possible combination to suit your needs As well for your convenience an optional rubber button insert has been included Replacing the Batteries Under normal conditions the batteries can last from to years During each button press the key will send the status of its battery to the control panel receiver If the batteries are low the trouble light on the controls panel's keypad will turn ON To replace the batteries remove the top cover by inserting a Panasonic CR V coin into the slot located on the bottom right corner and twist Remove the screw at the center of the board to expose the batteries Replace both batteries with Pana- sonic CR- lithium batteries see diagram NOTE The polarity of the battery must be observed as shown in the diagram above Improper handling of lithium batteries may result in heat generation explosion or ?re which may lead to personal injuries DANGER OF EXPLOSION IF BATTERIES ARE INSTALLED INCORRECTLY REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER Keep away from small children If batteries are swallowed promptly see a doctor Do not try to recharge these batteries Disposal of used batteries must be made in accordance with the