Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Egauge configuration guide for firmware v4 0 or newer

eGauge Con ?guration Guide for ?rmware v or newer eGauge Systems LLC Conestoga St Suite Boulder CO http egauge net June Before continuing we highly recommend checking out our basic overview guide at http egauge net help overview Overview This guide explains how to con ?gure eGauge so it properly re ects the physical reality of an installation There are three sections to this guide the ?rst is a brief introduction to the web pages used to con ?gure eGauge the second is the main section and consists of a list of examples re ecting common installation scenarios The third section contains tips on how to ?x up installation mistakes through the web con ?guration rather than having to go out to a site and correct the physical mistake eGauge establishes a few basic rules Following these rules is not strictly required but they help to keep things straight and properly working The direction in which the Current Transformers CTs point matters The white sticker on the CTs should always point towards the entity being measured For example towards the utility when measuring power from the power grid towards the inverter for solar and or wind generators towards appliances when measuring loads or towards the panels when measuring subpanels CeGauge Con ?guration Guide OVERVIEW Power readings that are positive numbers indicate that power is being delivered from the entity being measured whereas negative numbers indicate power being delivered to the entity For example when a solar system produces more power than a site uses the excess power is delivered back into the grid In this case the power reading for the grid will be negative since the grid is consuming the excess power To con ?gure eGauge start a compatible browser on a computer and connect to the device ? s web page See the Owner ? s Manual for details on how to do that Once connected to the device click on the ??LAN Access ? link in the top-right of the page This redirects the browser to a page ensuring a direct LAN connection to the device If the page does not load you will not be able to make changes to the device settings unless remote administration is enabled Please contact eGauge technical support for details on how to enable that Once the page has loaded click on the ??Settings ? link in the top-right of the page then click on ??Installation ? in the navigation-bar on the left of the new page As illustrated in Figure the Installation page has ?ve sections Potential Transformers PTs Sensors Remote Devices Registers Totals and Virtual Registers We describe the purpose of each section in more detail below After any of the settings have been changed they need to be saved by clicking on the ??Save ? button near the bottom of the page When doing that for the ?rst time you may be prompted for authorization to make the changes If the original purchaser of the meter has a