Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Manual Guide - Notebook Series I & II This manual covers two notebook series, a

Manual Guide - Notebook Series I & II This manual covers two notebook series, and this document contains two manuals with information relating to both notebook series. The main difference between the two notebook series is in the appearance as illustrated below. Within Notebook Series II there are different models (entitled Models A & B) with different design styles differing in color, general appearance and features supported. Note that your computer may look slightly different from those pictured throughout either manual. See Appendix D at the end of each manual for full specification details. If you need any assistance you can contact your distributor/supplier for further help. Feature Notebook Series I Notebook Series II Model A Model B Model A Model B Display Type 14.0” / 35.56cm HD (1366 * 768), 16:9 3.6mm thick Backlit Panel 15.0” / 39.62cm HD (1366 * 768), 16:9 Panel (Thickness: 3.8mm) OR 15.6” / 39.62cm FHD (1920 * 1080), 16:9 3.4mm thick Backlit Panel 14.0” / 35.56cm HD (1366 * 768), 16:9 Panel (Thickness: 3.6mm) For Design II Only: Multi Touch Screen 15.0” / 39.62cm HD (1366 * 768), 16:9 Panel (Thickness: 3.8mm) USB 2.0 Ports One USB 2.0 Port Two USB 2.0 Ports One USB 2.0 Port Two USB 2.0 Ports Keyboard A4 Size Isolated Keyboard Full Size Isolated Winkey Keyboard with Numeric Keypad A4 Size Isolated Keyboard Full Size Isolated Winkey Keyboard with Numeric Keypad Model Appearance V14.1.00 NOTEBOOK SERIES I I Preface Notice The company reserves the right to revise this publication or to change its contents without notice. Information contained herein is for reference only and does not constitute a commitment on the part of the manufacturer or any subsequent vendor. They assume no responsibility or liability for any errors or inaccuracies that may appear in this publication nor are they in anyway responsible for any loss or damage resulting from the use (or misuse) of this publication. This publication and any accompanying software may not, in whole or in part, be reproduced, translated, trans- mitted or reduced to any machine readable form without prior consent from the vendor, manufacturer or creators of this publication, except for copies kept by the user for backup purposes. Brand and product names mentioned in this publication may or may not be copyrights and/or registered trade- marks of their respective companies. They are mentioned for identification purposes only and are not intended as an endorsement of that product or its manufacturer. ©February 2014 Trademarks Intel, Pentium and Intel Core are trademarks/registered trademarks of Intel Corporation. II Preface R&TTE Directive This device is in compliance with the essential requirements and other relevant provisions of the R&TTE Direc- tive 1999/5/EC. This device will be sold in the following EEA countries: Austria, Italy, Belgium, Liechtenstein, Denmark, Lux- embourg, Finland, Netherlands, France, Norway, Germany, Portugal, Greece, Spain, Iceland, Sweden, Ireland, United Kingdom, Cyprus, Czech Republic, Estonia, Hungary, Latvia, Lithuania, Malta, Slovakia, Poland, Slov- enia. ErP Off Mode Power Consumption Statement: The figures below note the power consumption of this computer in compliance with European Commission (EC) regulations on power consumption in off mode • Off Mode < 0.5W III Preface CE Marking This device has been tested to and conforms to the regulatory requirements of the European Union and has at- tained CE Marking. The CE Mark is a conformity marking consisting of the letters “CE”. The CE Mark applies to products regulated by certain European health, safety and environmental protection legislation. The CE Mark is obligatory for products it applies to: the manufacturer affixes the marking in order to be allowed to sell his product in the European market. This product conforms to the essential requirements of the R&TTE directive 1999/5/EC in order to attain CE Marking. A notified body has determined that this device has properly demonstrated that the requirements of the directive have been met and has issued a favorable certificate of expert opinion. As such the device will bear the notified body number 0560 after the CE mark. The CE Marking is not a quality mark. Foremost, it refers to the safety rather than to the quality of a product. Secondly, CE Marking is mandatory for the product it applies to, whereas most quality markings are voluntary. IV Preface FCC Statement (Federal Communications Commission) You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in- stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Re orient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the service representative or an experienced radio/TV technician for help. Operation is subject to the following two conditions: 1. This device may not cause interference. And 2. This device must accept any interference, including interference that may cause undesired operation of the device. V Preface FCC RF Radiation Exposure Statement: 1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.  Warning Use only shielded cables to connect I/O devices to this equipment. You are cautioned that changes or modifications not ex- pressly approved by the manufacturer for compliance with the above standards could void your authority to operate the equipment. If your purchase option includes both Wireless LAN and 3G modules, then the appropriate antennas will be installed. Note that In order to comply with FCC RF exposure compliance requirements, the antenna must not be co-located or operate in conjunction with any other antenna or transmitter. Important Notice - 3G & Bluetooth/Wireless LAN Modules In order to comply with FCC regulations you should NOT operate the 3G module and the Bluetooth/Wireless LAN modules at the same time as this may disrupt radio frequency, and cause interference. When the 3G module is powered on, make sure that the Bluetooth/Wireless LAN modules are powered off. VI Preface IMPORTANT SAFETY INSTRUCTIONS Follow basic safety precautions, including those listed below, to reduce the risk of fire, electric shock, and injury to persons when using any electrical equipment: 1. Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool. 2. Avoid using this equipment with a telephone line (other than a cordless type) during an electrical storm. There may be a remote risk of electrical shock from lightning. 3. Do not use the telephone to report a gas leak in the vicinity of the leak. 4. Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions. 5. This product is intended to be supplied by a Listed Power Unit with an AC Input of 100 - 240V, 50 - 60Hz, DC Output of 19V, 2.1A (40 Watts) minimum AC/DC Adapter. This Computer’s Optical Device is a Laser Class 1 Product VII Preface Instructions for Care and Operation The notebook computer is quite rugged, but it can be damaged. To prevent this, follow these suggestions: 1. Don’t drop it, or expose it to shock. If the computer falls, the case and the components could be damaged. 2. Keep it dry, and don’t overheat it. Keep the computer and power supply away from any kind of heating ele- ment. This is an electrical appliance. If water or any other liquid gets into it, the computer could be badly dam- aged. Do not expose the computer to any shock or vibration. Do not place it on an unstable surface. Do not place anything heavy on the computer. Do not expose it to excessive heat or direct sunlight. Do not leave it in a place where foreign matter or mois- ture may affect the system. Don’t use or store the com- puter in a humid environment. Do not place the computer on any surface that will block the Vents/Fan Intakes. VIII Preface 3. Avoid interference. Keep the uploads/Industriel/ user-guide-w940su2 1 .pdf