Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Installation guide 7 Installation Guide Outdoor CPE CPE CPE CPE CPE Contents Overview Hardware Connection Site Consideration Connection and Installation Lightning ESD Protection Software Con ?guration Logging in to the PharOS Typical Application Con ?gura

Installation Guide Outdoor CPE CPE CPE CPE CPE Contents Overview Hardware Connection Site Consideration Connection and Installation Lightning ESD Protection Software Con ?guration Logging in to the PharOS Typical Application Con ?guration Antenna Alignment Speci ?cations FAQ Overview TP-Link's Pharos series outdoor CPEs are dedicated to outdoor wireless network solutions This guide is applicable to products including CPE CPE CPE and CPE ? Package Contents Power Cord Pole Mounting Straps Installation Guide Outdoor CPE Pharos CPE Passive PoE Adapter Mounting Bracket Plastic Wall Anchors Qty Self-tapping Screws Qty CPE CPE CPE CPE Installation Guide ? LED Explanation The following picture takes CPE as an example AP AP Router mode All four LEDs remain solid Client Bridge Repeater AP Client Router mode That the more LEDs lit will indicate better wireless signal strength On A device is connected to this port but there is no activity Flashing A device is connected to this port and is active On The CPE is powered on LAN LAN POWER ? Panel Layout Pharos CPE CPE Grounding Terminal Shielded Ethernet Shielded Ethernet Port LAN Passive Port LAN PoE in Pharos CPE CPE RESET Grounding Terminal Shielded Ethernet Port LAN Passive PoE in RESET Passive PoE Adapter Remote Reset Press and hold for seconds to reset the CPE to its factory defaults Power LED The Power LED is on when the passive PoE adapter is working normally Hardware Connection Site Consideration ? Mounting Height Ensure a clear line of sight between the wireless devices for an optimum performance An elevated location is recommended as obstacles like trees buildings and large steel structures will weaken the wireless signal See 'Q ' in 'FAQ' for details about how to calculate the minimum mounting height of the devices Line of Sight Side View ? Orientation Install the CPE devices with the front facing the intended signal receiving devices You can orient the devices with the assistance of Google Maps GPS and some landmarks according to the horizontal beamwidth listed below Models CPE Horizontal Beamwidth CPE CPE CPE shenzhen A HoBreizaomnwtaildth B Line of Sight Connection and Installation Connect and mount the CPE and power adapter as shown below The following introduction takes CPE as an example ? Connecting CPE and Power Adapter Connect the CPE and power adapter as shown in the ?gure below LAN PoE LAN Ethernet cable length up to m Slide to replace the cover of the CPE when all connections are ?nished You should prepare an adequate Ethernet cable to connect the CPE and the passive PoE adapter Shielded CAT e or above cable with ground wire is recommended refer to the next section Connect to a computer router or switch Depending on your intended usage and or network topology ? Mounting CPE At the selected site approximately align the CPE to the direction that you have oriented ? Mounting Power Adapter Optional Follow the steps below to mount the power adapter To ensure the passive PoE adapter is attached most securely it is recommended