Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Koolprog user guide User Guide KoolProg http koolprog danfoss com User Guide KoolProg Table of contents Introduction Downloading exe ?le System requirements Installing software Connection with controllers Starting the program Set parameters Copy to contro

User Guide KoolProg http koolprog danfoss com User Guide KoolProg Table of contents Introduction Downloading exe ?le System requirements Installing software Connection with controllers Starting the program Set parameters Copy to controller On-line service Unknown controller support Introduction Downloading exe ?le Con ?guring and testing the Danfoss electronic controllers has never been so easy with the new KoolProg PC software With one KoolProg software you can now take advantage of new intuitive features such as the selection of favorite parameter lists writing online as well as o ine program ?les and monitoring or simulating alarm status activities These are only some of the new features that will minimize the time R D and production will spend on development programming and testing the Danfoss range of commercial refrigeration controllers Supported Danfoss products ETC H EETc EETa ERC ERC EKE A B C AK-CC The following instructions will guide you through the installation and ?rst time usage of KoolProg Download KoolProgSetup exe ?le from the location http koolprog danfoss com System requirements This software is intended for a single user and recommended system requirements as below OS RAM HD Space Required software Interface Windows Windows bit and bit GB RAM GB and GB MS O ?ce and above USB Macintosh operating system is not supported Running the setup directly from windows server or network ?le server is not recommended BC en- ? Danfoss DCS vt User Guide KoolProg Installing software ? Double click on the KoolProg setup icon Run the installation wizard and follow the onscreen instructions to complete the KoolProg installation Connection with controllers Note If you encounter a Security warning during installation please click on Install this driver software anyway Fig For EET using KoolKey and cable ?? Danfoss G Type C USB To COM ?? Connect the KoolKey to PC's USB port Connect the controller to KoolKey using communication cable ? Danfoss DCS vt BC en- User Guide KoolProg Fig For ERC and ETC using Danfoss gateway Code No G ETC HX ERC X ERC X TTL port Interface cable for ERC X di port Interface cable for ERC X port port Interface cable for ETC Gateway USB A USB B cable To PC Connect USB cable to the PC's USB port Connect the controller CAUTION Please ensure that only one controller is connected at any time Fig Mass programming of EET and ERC controllers For EET Insert the KoolKey to PC's USB port and save the con ?g ?le created using KoolProg in Nxxxx xml format where xxxx are code no of the controller For ERC Connect EKA programming key to USB port of PC laptop and transfer the ?le in erc format from computer to the programming key BC en- ? Danfoss DCS vt User Guide KoolProg Transferring the ?le from KoolKey to EET controller For EETa the controller has to be powered with main power or KoolKey must powered with V supply For EETc the KoolKey has to be mandatorily powered up with V supply CAUTION