Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Tps control guide User guide TPS Control Atlas Copco Tools and Assembly Systems Edition - CCopyright Atlas Copco Tools and Assembly Systems Note This manual can be altered without further notice For further information log in to Atlas Copco www atlascopco

User guide TPS Control Atlas Copco Tools and Assembly Systems Edition - CCopyright Atlas Copco Tools and Assembly Systems Note This manual can be altered without further notice For further information log in to Atlas Copco www atlascopco com CTable of content Contents TPS Control User Guide Introduction Safety and operating instructions System overview TPS controller Setup Start TPS Set up TPS Connect to tool controllers Operation Quick guide Job handling Maintenance Firmware updates Reference Parameters I O con ?guration Licence handling Result reporting Barcode scanning C C Introduction Introduction Safety and operating instructions T WARNING Read all warnings and all instructions The safety and operating instructions as described in the Atlas Copco Product instructions that is included in the delivery of the system must be read and complied Ensure that you read and understand all instructions Failure to follow all the instructions may result in electric shock ?re and or serious personal injury All locally legislated safety regulations with regard to installation operation and maintenance must be adhered to at all times Refer installation and servicing to quali ?ed personnel only Save all instructions for future reference Contact your Atlas Copco representative if questions regarding the safety and operating instructions arise System overview This user guide describes how to install con ?gure and use the Tool Positioning System TPS Control TPS Control is used for controlling and monitoring tightening sequences and positioning operations for a variety of pneumatic and electronic tools The TPS Control system is designed for the modern assembly industry with high demands on quality and production e ?ciency and o ?ers full modularity through the combination of di ?erent hardware and software CIntroduction J JOB MOTOR P Cycle RESET F F F ESC MENU OK INFO VAL START NOK RESET A typical setup of the TPS contains the controller itself connected to a screwdriver and torque arm with external operating and display elements and a digital I O cable to a tool controller The TPS can either be used with a single tool or be connected to a torque arm that holds the tool If the controller is used with a torque arm it is equipped with a distance and angle sensor and can detect the position of the screw currently being handled The TPS primarily monitors the sequence of screws and the tightening program with and without position control The TPS can easily be connected to di ?erent tool controllers using digital VDC signals These digital input and output signals are used to enable and control workstations The OK NOK classi ?cation of the individual tightening operations is handled by the tool controllers which transmits these results through the digital input signals to the TPS Control The TPS has digital inputs and digital outputs In TPS the complete sequence de ?nition for a work piece is called a job The TPS can store up to jobs with a total of sequence element memories for positions available for these jobs These sequence elements CIntroduction can be