Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Guide 883 en iMac G Model A Display Replac ? Guide ID - Draft - - iMac G Model A Display Replacement Written By Andrew Bookholt This document was generated on - - AM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CiMac G Model A Display Replac ? INTRO

iMac G Model A Display Replac ? Guide ID - Draft - - iMac G Model A Display Replacement Written By Andrew Bookholt This document was generated on - - AM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CiMac G Model A Display Replac ? INTRODUCTION Guide ID - Draft - - Use this guide to replace the monster LCD housed within your iMac TOOLS Phillips Screwdriver Spudger TR Torx Security Screwdriver PARTS iMac G EMC No and LCD Assembly This document was generated on - - AM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CiMac G Model A Display Replac ? Step ?? Rear Panel Step Guide ID - Draft - - Lay the iMac display-side down on a at surface Loosen the three Phillips screws securing the rear panel to the E iMac These screws are captive in the iMac The center screw will stop turning after about turns and the outer screws will stop turning after about turns Do not try to remove these screws from your iMac Lift the rear panel slightly near the bottom of the iMac Pull the rear panel toward yourself and remove it from the iMac This document was generated on - - AM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CiMac G Model A Display Replac ? Step ?? RAM Guide ID - Draft - - Rotate each of the two RAM retaining arms away from the RAM chip E Pull the RAM chip straight away from its socket Repeat this process for E the other RAM chip Be sure the RAM arms are rotated fully outward before installing new RAM chips This document was generated on - - AM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CiMac G Model A Display Replac ? Step ?? Inverter Guide ID - Draft - - Remove the following three screws securing the inverter to the chassis Two mm Phillips One mm E Phillips When reinstalling the inverter be careful to route the purple and black cables around the screw mount It is very easy to pinch the cable and damage the insulation This document was generated on - - AM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CiMac G Model A Display Replac ? Step Guide ID - Draft - - Slide the inverter toward the edge of the mid-plane then lift it out of the E E iMac Be careful to not pry up against the RAM brackets When reinstalling the inverter press the blue and white cables down in the edge of the midplane before lowering the inverter down into the midplane The black cable can be routed near the hard drive thermal sensor cable This document was generated on - - AM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CiMac G Model A Display Replac ? Step Guide ID - Draft - - Disconnect the large