Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

A10 rack 4 slot wireless enclosure user guide

A -RACK -Slot Wireless Enclosure ?? User Guide ?? Fits Most Unislot and Superslot Receivers CA -RACK User Guide Copyright Doc Rev History Info Copyright ? Audio Ltd All rights reserved www audioltd com Century Court Tolpits Lane Watford WD RS UK info audioltd com Revision A B A Date Sept Sept Nov Description Initial - Publication Added info to Operation and A -RX Firmware Update sections Added info on User Groups Table of Contents Copyright Doc Rev History Info Overview Key Features Compatible Receivers Panels Connectors Controls and More Rack Mounting Powering Dante Installing Receivers Operation Updating RX via A -RACK Cascading A -RACK Units Operational Block Diagram Speci ?cations Legal Notices - - CA -RACK User Guide Overview The A -RACK is a slot channel RU wireless microphone receiver enclosure compatible with most Unislot and SuperSlot receivers The A -RACK accepts up to dual-channel slot-in receivers providing a total of separate audio feeds The A -RACK provides high-quality antenna distribution power distribution up to channels of analogue and or AES digital audio via XLR-M connectors and an channel Dante audio interface ? ? Slot-in receivers are sold separately Key Features ? Dante audio network integration for up to four Superslot compatible wireless mic receivers eight audio channels such as Audio Limited ? s A -RX as well as some models by Wisycom and Lectrosonics ? Antenna distribution with V power for active antennas and pass-through for a second A RACK for a total of audio channels ? Powering distribution via -pin XLR-M socket - VDC ? Analogue or AES outputs via eight XLR-M sockets on rear panel ? Each receiver can be set to output analogue or AES individually if supported by receiver ? Simultaneous analogue AES and Dante outputs ? Secondary Ethernet port for Dante redundancy or daisy-chaining second A -RACK ? USB-B port for updating RX ?rmware via Mic Wav app ? - MHz front-end RF ?lter bandwidth ? RU chassis size with adjustable rack ears to set required depth Compatible Receivers The A -RACK ?ts slot-in receivers with maximum dimensions of ? Slot height mm inches ? Slot width mm inches ? Width between SMAs mm inches - - CA -RACK User Guide Panels Connectors Controls and More Figure Full Front Panel of A -RACK Figure Closeup of Leftmost Slot on Front Panel of A -RACK -Four Receiver Slots Each slot accepts one single- or dualchannel -pin SuperSlot or unislot receiver The connection provides power to the receiver and connects the receiver ? s audio output directly to the appropriate rear panel XLR connector and to the Dante interface -Antenna Distribution Leads SMA cables included are used to connect receivers to the A -Rack antenna distribution system -Rack Ears One of two pictured Used for mounting A -Rack chassis to a -inch rack - - CA -RACK User Guide Figure Full Back Panel of A -RACK -Antenna Inputs Antenna inputs via two Ohm BNC sockets V DC bias supply available to power active antennas -Antenna