Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

User guide 46 Introduction This User's Guide is used for the M PCI Adapter with wake on L AN function which supports M B with PCI spec It is a -bit adapter for using in personal computers with a Peripheral Component Interconnect PCI computer bus to elimin

Introduction This User's Guide is used for the M PCI Adapter with wake on L AN function which supports M B with PCI spec It is a -bit adapter for using in personal computers with a Peripheral Component Interconnect PCI computer bus to eliminate I O bottle necks and to reduce CPU loading using bus master architecture Wake on LAN for PCI fun ction supp orts you to tur n on PCs from a sle ep state over the network remotely during o ?-hours It is a Full- Duplex adap ter conne cted to an Ethernet network with a single connection over unshielded twisted pair UT P c able and can auto -sen se e ither Mbps or Mbps by full auto- detection Key Features ? Single-chip co ntr oller co mplies to PCI local b us speci ?cation revision ? Conform with IEEE BASE-T and IEEE u BASE-TX standards ? Support Wake on LAN function Work with PCI motherboard ? Support ACPI PCI power management Work with PCI motherboard ? High performance bus master architecture for low CPU and bus utilization ? Single RJ- connector for using at either or Mbps speed ? On-board socket for an o ptional remote boot ROM ? Provide diagnostic LED to monitor linking status ? Provide high performance network drivers such as ODI NDIS NDIS NDIS NDIS UNIX etc Package Contents ? One Ethernet PCI adapter ? Driv er Disk ette ? One User's Guide The Card Layout Each card is clearly displayed below with major components M PCI Adapter Wake on LAN PCI Adapter Support P CI For Wake o n LAN Funct ion Wit h Ca ble LED RJ- Boot Rom Socket optional Controller Chipset LEDIndicator The LED indicators o n the re ar brac ket of e ach card for tracking network linking status When working on PCI for Wa ke O n LAN LINK ACT The LED ONindicates green when the card is connec ted to M network The LED indicators ash when there is trans mission of data occurring at the card LINK ACT RJ- JACK CInstallation Procedures Discharge any static electricity from your body before handling the sensitive board of the card Handle the card by its edges and be careful not to twist or ex it Follow the steps l Unpack the card package apply the power when installing Turn o ? any devices that l Remove your computer's unit cover Refer to your computer system manual fo r speci ?c instructions l Locate a f ree PCI local bus ma ster slot l Remove the slot cover and screw l Insert the card into the chosen and correct slot carefully l Put the computer's unit cover back Making Network Connection TwistedPair Cable Connection Twisted pair cable is used in conjunction with the RJ- modular plug on the rear bracket To make the connection per- l Make sure the power to your computer is o ? to avoid damage to both the computer and the network