Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Ender5 build guide Build Guide - Ender ExoSlide XY Motion Kit www exoslide com C Corner Bracing to keep the same travel Parts Needed Corner brace x M x bolt x M T nut x x Notes -Remove the front aluminum corner braces and install the supplied shorter brac

Build Guide - Ender ExoSlide XY Motion Kit www exoslide com C Corner Bracing to keep the same travel Parts Needed Corner brace x M x bolt x M T nut x x Notes -Remove the front aluminum corner braces and install the supplied shorter braces Do this before loosening the front Y belt brackets to keep the alignment V-wheel Bracket Removal -Loosen front Y belt brackets -Remove all V- wheel brackets X bracket and both Y brackets -Leave Y belts draped over the frame -Put aside two M x bolts from the Y brackets and the M bolt nuts and bearings from the Y belt tensioner on your Ender printer Tensioner Bracket Assembly Parts Needed Tensioner bracket x M x bolts x M T nut x Re-use M bolt nuts bearings C Idler Bracket Assembly Parts Needed Idler brackets x M x bolt x M T nut x M x bolt x M washer x M thin nut x M locknut x F bearing x Re-use M x bolt Motor Bracket Assembly Parts Needed Motor brackets x M x bolt x M T nut x M x bolt x M x bolt x M washer x M thin nut x M locknut x F bearing x Re-use Motor M x bolt X Carriage Assembly Parts Needed ExoSlide PC x Carriage bracket x M x bolt x M x bolt x M x bolt x M x spacer x CNotes -Tighten the eight M x Nylock bolts down ?rmly that secure the four ExoSlides together Endstop Assembly Parts Needed Endstop bracket x M x bolt x M T nut x Re-use M x bolts endstop Gantry Assembly Parts Needed Tensioner bracket assembly x Idler bracket assembly x Motor bracket assembly x X carriage assembly x Endstop assembly x Bracket mm x Belt x Re-use cross rail CNotes -Install the idler bracket assembly and the motor bracket assembly with the long M x bolts screwed into the tapped holes at the ends of the extrusion -Install the black plastic brackets with the tabs pointing to the ends of the rail Leave the bolts loose and the brackets roughly mm away from the aluminum brackets -Nest the endstop switch into the top of the black plastic bracket Y Carriage Assembly Parts Needed ExoSlide PC x M x bolt x Endstop Y x Notes -Tighten the four M x bolts down ?rmly that secure the ExoSlides together Y ExoSlide Parts Needed ExoSlide PC x C Motion Assembly Parts Needed Gantry assembly x Y carriage assembly x Y ExoSlide x M x bolt x Notes -Place the gantry assembly over the rails then install the Y belts ?rst -Now slide the black brackets to line-up with the ExoSlides two farthest holes -Then tighten the Y and X if not done yet belts -Go make stu ? C