Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Disassembling DualShock 4 Motherboard Assembly Disassemble the motherboard with

Disassembling DualShock 4 Motherboard Assembly Disassemble the motherboard with its attached analog sticks and vibration motors. Written By: Maaz Hussaini Disassembling DualShock 4 Motherboard Assembly Draft: 2019-09-04 Guide ID: 22679 - This document was generated on 2019-09-16 03:01:39 PM (MST). © iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7 INTRODUCTION Use this guide to disassemble the motherboard assembly from the front and rear cover. TOOLS: Phillips #00 Screwdriver (1) iFixit Opening Tools (1) PARTS: DualShock 4 Controller Motherboard and Midframe Assembly (JDM-011) (1) DualShock 4 Controller Motherboard and Midframe Assembly (JDM-001) (1) DualShock 4 Controller Motherboard and Midframe Assembly (JDM-020) (1) Disassembling DualShock 4 Motherboard Assembly Draft: 2019-09-04 Guide ID: 22679 - This document was generated on 2019-09-16 03:01:39 PM (MST). © iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7 Step 1 — Controller Using the Phillips #00 Screwdriver, remove the four 6.0 mm screws securing the rear cover to the controller.  Do not forcefully loosen the screws, as it will amount to permanent damage of the threads, making removal impossible.  Step 2 Beginning with the left handle:  Pinch the left handle of the controller to introduce an opening.  Wedge a plastic opening tool into the opening and slide it up towards the joystick.  Pull down on the plier to crack open the casing.  Repeat these steps for the right handle.  Disassembling DualShock 4 Motherboard Assembly Draft: 2019-09-04 Guide ID: 22679 - This document was generated on 2019-09-16 03:01:39 PM (MST). © iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7 Step 3 Wedge a plastic opening tool into the case-splittings and pull down to crack open the casing near the following buttons:  Share button  Options button  Split the plastic covers of the controller apart, taking note that they will still be attached by circuit board ribbons.  Three small pieces are often released from the framework. To prevent loss, maintain a controlled work field.  2 Trigger Springs  1 Grey Reset Button Extension  Disassembling DualShock 4 Motherboard Assembly Draft: 2019-09-04 Guide ID: 22679 - This document was generated on 2019-09-16 03:01:39 PM (MST). © iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7 Step 4 — Disassembling DualShock 4 Motherboard Assembly Remove the single 6.0 mm Phillips screw found below the battery retainer with the Phillips #00 Screwdriver.  Do not forcefully loosen the screw, as it may amount to permanent damage of the threads, making removal impossible.  Step 5 Gently detach the touchpad ribbon connected to the motherboard using the blunt forceps. The touchpad ribbon is connected to the motherboard by a connector that flips to tighten and loosen. During reassembly, to reattach the ribbon, the plastic tray will need to be gently removed from the motherboard and the flip-lock flipped up.  Disassembling DualShock 4 Motherboard Assembly Draft: 2019-09-04 Guide ID: 22679 - This document was generated on 2019-09-16 03:01:39 PM (MST). © iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7 Step 6 Carefully dislodge the motherboard assembly from the front cover.  Vibration motors are loosely attached to the motherboard assembly. Provide support at the two ends to ease the separation.  When removing the motherboard assembly, try not to tilt the front cover upside down as the buttons and their covers may fall out.  Disassembling DualShock 4 Motherboard Assembly Draft: 2019-09-04 Guide ID: 22679 - This document was generated on 2019-09-16 03:01:39 PM (MST). © iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7 To reassemble your device, follow these instructions in reverse order. Step 7 — Disassembly Complete Successful disassembly of the controller will result in the following three parts, respectively:  Motherboard Assembly  Front Cover  Rear Cover  Disassembling DualShock 4 Motherboard Assembly Draft: 2019-09-04 Guide ID: 22679 - This document was generated on 2019-09-16 03:01:39 PM (MST). © iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7 uploads/s1/ guide-22679.pdf