Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Operation amp maintenance manual paaadf

on ?dential Operation and Maintenance Manual for DC Power Supply Zinex Corporation Oxnard CA www Zinexcorp com CTABLE OF CONTENTS Introduction Receiving and UnPacking Installation Mechanical and Electrical Features Controls and Indicators Trouble Shooting Maintenance Safety Warranty See PLC-HIO Manual on ?dential Con ?dential INTRODUCTION Zinex Corporation DC Power Supply is a high quality general purpose DC power source The power supply provides DC output linearly adjustable for precise settability Please read and save these instructions Extreme care has been taken to insure the safe arrival of our products to their ?nal destination However we rely on the carriers for safe transportation In order to protect our customers against any ?nancial loss we would recommend the following Receiving and Unpacking ? Inspect the crate or packing visually and determine whether it has been broken or damaged ? If there is any visible damage to the crate DO NOT uncrate or unpack ? Notify the carrier immediately The carrier will then notify their insurance company and an adjuster will visit your plant for approval of damage Please DO NOT send the damaged crated unit back to Zinex Corporation However Zinex Corporation should be noti ?ed of any damage to the equipment ? When moving the recti ?er around with a HI ??Low or Forklift you must make sure the forks extend out through the bottom on the enclosure pallet onto the other side This will ensure that no damage to the unit will occur during moving DO NOT lift the unit from the lifting provided on the lid of the recti ?er tank These lifting hooks are provided for lifting the lid only ? If there is NO external damage they can now be opened ? Remove all packaging material internal and external from the unit Remove all panels and look for any damage including water or corrosion inside which might have occurred in shipment If there is any damage to the internal components DO NOT TRY TO REPAIR Notify the carrier immediately ? Make sure all parts are bolted securely to its appropriate position and check if there are any loose connections Bus bar power wiring and control wiring Tighten any loose wires If any wire is out of its appropriate place and you are not sure where it was connect Please contact Zinex Corporation ? Replace all panels torque where applicable to prevent moisture damage Recti ?er top cover and control component cover should be torque to ?? ft lb Con ?dential INSTALLATION Mechanical Installation Special foundation is not required other than level oor capable of withstanding the weight of the Oil Cooled Recti ?er The equipment is self-supporting However bolt down provisions are supplied if required Installation indoors outdoors Maximum ambient temperature should not exceed C It is preferable to install these units under sunshield to prolong life of the units Ceiling of the room should be at least ten feet higher than the top of the recti ?er DO NOT mount any piping wiring ext over the