Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Guide 22679 Disassembling DualShock Motherboard Assembly Guide ID - Draft - - Disassembling DualShock Motherboard Assembly Disassemble the motherboard with its attached analog sticks and vibration motors Written By Maaz Hussaini This document was generate

Disassembling DualShock Motherboard Assembly Guide ID - Draft - - Disassembling DualShock Motherboard Assembly Disassemble the motherboard with its attached analog sticks and vibration motors Written By Maaz Hussaini This document was generated on - - PM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CDisassembling DualShock Motherboard Assembly INTRODUCTION Guide ID - Draft - - Use this guide to disassemble the motherboard assembly from the front and rear cover TOOLS Phillips Screwdriver iFixit Opening Tools PARTS DualShock Controller Motherboard and Midframe Assembly JDM- DualShock Controller Motherboard and Midframe Assembly JDM- DualShock Controller Motherboard and Midframe Assembly JDM- This document was generated on - - PM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CDisassembling DualShock Motherboard Assembly Step ?? Controller Guide ID - Draft - - Using the Phillips Screwdriver E remove the four mm screws securing the rear cover to the controller Do not forcefully loosen the screws as it will amount to permanent damage of the threads making removal impossible Step Beginning with the left handle Pinch the left handle of the controller to introduce an opening Wedge a plastic opening tool into the opening and slide it up towards the joystick Pull down on the plier to crack open the casing Repeat these steps for the right handle This document was generated on - - PM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CDisassembling DualShock Motherboard Assembly Step Guide ID - Draft - - Wedge a plastic opening tool into the case-splittings and pull down to crack open the casing near the following buttons Share button Options button Split the plastic covers of the controller apart taking note that they E will still be attached by circuit board ribbons Three small pieces are often released from the framework To prevent loss maintain a controlled work ?eld Trigger Springs Grey Reset Button Extension This document was generated on - - PM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CDisassembling DualShock Motherboard Assembly Guide ID - Draft - - Step ?? Disassembling DualShock Motherboard Assembly Remove the single mm Phillips screw found below the battery retainer with the E Phillips Screwdriver Do not forcefully loosen the screw as it may amount to permanent damage of the threads making removal impossible Step Gently detach the touchpad ribbon connected to the motherboard using the blunt forceps The touchpad ribbon is connected to the motherboard by a connector that ips to tighten and loosen During reassembly to reattach the ribbon the plastic tray will need to be gently removed from the motherboard and the ip-lock ipped up This document was generated on - - PM MST ? iFixit ?? CC BY-NC-SA www iFixit com Page of CDisassembling DualShock Motherboard Assembly Step Guide ID - Draft - - Carefully dislodge the motherboard assembly from the front cover Vibration motors are loosely attached to the motherboard assembly Provide E support at the two ends to ease the separation When