Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a

Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd. PDA Scanner - HT682 - Quick Reference Guide 400975G Version 0.1 Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd. HT682 Product Introduction & Accessory Kit HT682 PDA Scanner Manual CD Communication Cable Battery Adaptor Plugs Communication Cradle Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd. HT682 Front View LED Indicator Touch Screen Display Trigger Alpha Function Power I/O Port Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd. HT682 Rear View Bar Code Scanner Stylus Speaker Battery Cover Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd. First Step with HT682 Before first using the HT682, please ensure the battery is fully charged. There are three ways to charge your HT682: z Docking Station z USB/Charging cable z Rechargeable Lithium-Ion battery pack NOTE: Data loss may occur if the HT682's backup battery is not adequately charged. Before charging the main battery, make sure the backup battery switch is ON. Install the Battery Pack 1. Remove the battery cover. 2. Move the backup battery switch to the ON position (see the description below). 3. Insert the battery pack so that the contacts on the battery pack line up with the contacts in the battery compartment. Fully seat the battery. Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd. 4. Cover the battery. Switch On Backup Battery Locate the backup battery switch inside the battery compartment on the left-hand side. Please ensure that it is in the “ON” position before charging the main battery. Supply Power to the HT682 Connect the USB/Charging Cable to the HT682 and connect the AC adapter to the cable’s power jack and an electrical outlet. Or place the HT682 into the Docking Station (first connect the power supply to the Docking Station). Charge the Battery for the First Time We would like to propose to charge the battery at least up to 16 hours for the first time to use. While it normally only takes about 4 hours to charge the battery after it's been drained, when charging the battery for the first time please allow at least 16 hours. While charging the main battery the backup battery should also be charged. Please make sure the backup battery has been switched “ON” (this cannot be emphasized enough). Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd. CAUTION: There is a high risk of data loss from RAM if the backup battery is not fully charged. This can happen if the main battery has been drained and the unit is not connected to the AC adaptor. For this reason, it is crucial that the backup battery is switched on before charging the main battery for the first time. Keypad Data can be entered into the HT682 via its keypads, which includes: 0~9, alpha, function, escape, enter, scanner trigger, cursor, and on/off keys. Scan Key Enter Key Escape Key Function Key Alpha Key Cursor Key Power ON/OFF Key Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd. uploads/Management/ quick-reference-guide.pdf