Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

G1620 guide IP-Pipe G Quick GuideG Interconnect Network Con ?gurations ??Master ? E T Interface G IP Network ??Slave ? G E T Interface Figure E T Leased Line Connection over IP Network Figure E T over Outdoor b g Wireless IP Bridge CCommand Line Interface

IP-Pipe G Quick GuideG Interconnect Network Con ?gurations ??Master ? E T Interface G IP Network ??Slave ? G E T Interface Figure E T Leased Line Connection over IP Network Figure E T over Outdoor b g Wireless IP Bridge CCommand Line Interface Set Terminal COM port as baud None parity data bit stop bit and connect to the Console port UART A for using CLI Commands in Chapter of ??IP-Pipe G User Manual ? contained in the Manual CD A G Pair Installation Steps Usually one master and one slave G s are pre-con ?gured for a G pair The process of installing a G pair involves the following steps Planning for G interconnect network con ?gurations Installing the G BaseT Ethernet and E T cabling connections Using CLI command UART A to display E T Bitstream Interface B and Ethernet Service Interface C parameters Con ?guring CES Ethernet and E T interfaces parameters Verifying the E T connection of the G pair over Ethernet connection Example Ethernet back-to-back as in Figure Check the physical hookup for correctness The G requires an E T cross cable in its connection to the E T source An Ethernet cross- cable is also required for two G s in Ethernet back-to-back connection A PC or dumb terminal connection to the console port must use a null modem RS cross cable with settings of N Check that the Ethernet con ?guration parameters are correct RTP header must be selected for IP packet and choose payload per packet say bytes The following CLI command displays the bitstream interface con ?guration Con ?g Interfaces Interface C gc Current con ?g Working mode ETH MII RMII MII AutoNeg ON Speed Mb s - Next start up con ?g ETH MII ON - CDuplex Mode Flow control Disabled Clock source DTE RMII ref clock out Interface BW kb s Unlimited MAC address CD CD CD CD CD CD MAC Loopback Enabled PHY con ?gured YES PHY number Advertisement H F H F Disabled DTE Unlimited CD CD CD CD CD CD Disabled YES H F H F Be sure that the LIU con ?guration parameters are compatible with the E signal source line code line build out etc The following CLI command displays the bitstream interface con ?guration Con ?g Interfaces Interface B gc Current con ?g Working mode BitStream Frame Size bytes Underrun value xFE Clock source Loopback-master Tx clock polarity Falling Rx clock polarity Rising Interface loopback Disabled LIU line format E LIU type DL LIU line code HDB LIU line build out E LIU rx term ohm LIU monitor gain Norm LIU Rx Equalizer Gain Limit - db LIU Jitter Attenuation Disabled LIU loopback Disabled Next start up con ?g BitStream xFE Loopback-master Falling Rising Disabled E DL HDB E ohm Norm - db Disabled Disabled CThe Interface C gs command shows whether the link to the Ethernet is operational and whether the PHY has connected properly Check your settings if this status