Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Prisma guide Quick Start Guide Conventional UT Phased Array TOFD CTable of contents Introduction to your new device Inserting and charging the battery for the ?rst time Booting the unit Connecting probes and USB memory stick Load an existing con ?guration

Quick Start Guide Conventional UT Phased Array TOFD CTable of contents Introduction to your new device Inserting and charging the battery for the ?rst time Booting the unit Connecting probes and USB memory stick Load an existing con ?guration Create a con ?guration Starting data acquisition Understanding the conventional UT screen layout Navigating through menus and views Keypad Keypad de ?nition table Adjusting gain Automatic gain adjustment Calibration wizards for conventional UT TOFD option Creating a TOFD setup Calibrating a TOFD setup Understanding what you look at Phased array Option Understanding at the phased array screen layout Moving the A-scan Extractor cursor Moving the Top End view box Adjusting the focus focal laws Calibration wizards for phased array Manipulating cursors Cartesian Angular Gate Extractor Box and Extractor Adding cursors Making measurements with gates Customizing the Measurements bar Taking screenshots and building reports De ?ning scan plan geometry cartesian axis reference system Wedge references Group reference Part datum Setting up position-encoded or time-encoded scans Setting up an encoded scan Selecting a layout with appropriate views Menu tree menu items vary according to the inspection setup Ruler and axis color map Power LED Behavior C Color palettes Features not covered in this document Encoder Connector Pin out I O Connector Pin out De ?nitions Scan types Sectorial scan Linear scan Mono scan conventional UT TOFD scan Copyright disclaimers and certi ?cations Copyright Disclaimer of liability Certi ?cation electromagnetic compatibility V C Introduction to your new device Before starting make sure that your Prisma kit includes the following Drawing unit battery and charger Make sure you have the appropriate probes wedges and encoder for the type of inspection you intend to perform You may also use the Prisma demo kit which includes a basic set of accessories necessary to complete the scenarios described in this document V C Inserting and charging the battery for the ?rst time Drawing unit back Unscrew the back door and insert the battery Remove the waterproof rubber cover over the AC input socket and connect the AC power adaptor Before using it for the ?rst time the battery must be charged for at least hours however the unit can be used while charging An optional external battery charger and additional battery packs can be added in order to reduce downtime and increase productivity V C Booting the unit The following is the procedure to boot the Prisma unit Press the ON OFF key Please wait the Prisma requires seconds for a full cold-boot process At the end of the boot process the graphical user interface GUI appears Drawing startup screen V C Connecting probes and USB memory stick The following is the procedure to connect probes and a USB memory Connect the probe to the appropriate connector Drawing UT connectors In order to connect phased array probes unscrew and remove the grey protective cap that covers the I-PEX connector located on the right-hand side of the Prisma The cap can be stored on the unit by screwing it